*NEW* CDL3 Track Kits

CDL3 Track Kit

Tip: To understand how these looms connect, watch our introductory video on CDL3 Track Kits and watch our video on CDL3 and CAN based OBD  

ECU Adapter Looms

These looms enable the CDL3 to connect quickly and easily to your vehicle's ECU - whether factory or aftermarket - to access important engine data for display and/or logging. Some of the common channels received are:

  • Engine RPM

  • Throttle position (engine)

  • Engine temperature

  • Manifold Absolute Pressure (MAP)

  • Inlet air temperature

  • Mass Air Flow (MAF)

  • Barometric pressure

  • Load point

  • Exhaust temperature

 
The loom you will need depends on the ECU in your vehicle:

  ECU Adapter Looms Description 
OBD-II ECU connector

CDL3 to OBD-II Loom

The OBD-II loom is a plug-in adapter that connects the CDL3 terminated loom (supplied in CDL3 Track Kits) to the standard, on-board diagnostics port of many modern vehicles.

This enables the CDL3 to display and log a selection of channels, which differs from car to car.

Vehicle compatibility will vary from region to region, but as a guide most cars built after 2007 have an OBD-II connector.

Download datasheet

 CAN ECU connector

CDL3 to CAN ECU Loom

This plug-in adapter joins the CDL3 terminated loom (supplied in CDL3 Track Kits) to the standard MoTeC CAN communications connector used by MoTeC M84, M400, M600 or M800 ECUs. It makes 70+ ECU channels available to the CDL3.

This loom will also work with other manufacturers' CAN-based ECUs, with the exception that the round AMP connector must be removed and replaced with a suitable connection for the relevant ECU.

Download datasheet

 RS232 ECU connector

CDL3 to RS232 ECU Loom

The RS232 ECU loom joins the CDL3 terminated loom (supplied in the CDL3 Track Kits) to the D9 RS232 communications connector used by MoTeC M4, M48 or M8 ECUs.

This loom will also allow connection to many other RS232-based aftermarket ECUs; custom communication templates may be required.

The RS232 ECU loom can provide 40+ ECU channels to the CDL3.

Download datasheet


Other Accessories

CDL3 I/O Loom

CDL3 I/O Loom

This is a high quality, ready made loom that adds 4 analogue voltage inputs and 2 analogue temperature inputs to your CDL3 terminated loom, quickly and easily. The loom has been made so that it is simple to install, with minimal wiring required. Each of the six 2.5 metre leads is individually twisted and heat shrunk for a professional finish.
 
To use this loom the optional CDL3 12 I/O Upgrade must be enabled.

Download datasheet

Curly Cord

Curly Cord

Our plug-in curly cord allows the CDL3 Track Kit buttons to be moved onto the steering wheel with ease. The loom is pre-terminated with a 6 pin DTM, and has 6 straight through wires, allowing for additional buttons if required.

Download datasheet


Supplied items may differ slightly to these images.