SDL Can error

by **Vlad** on Sat Oct 12, 2019 10:44 pm

Good day, we are out a hillclimb race, and i keep getting this error on the dash, it’s random. Everithyng is working fine, connected over can wit an M84. When the driver stops the car, and start’s it back, it appears. After a ‘upgrade dash version’ it works again.Thank you, Vlad.

by **Vlad** on Sun Oct 13, 2019 2:24 am

Update: The update dash version is not working anymore....it just stays in the screen above.

by **David Ferguson** on Sun Oct 13, 2019 4:33 am

I suggest you send it to your dealer for repair. Certainly seems voltage or flash memory related.

by **Vlad** on Sun Oct 13, 2019 5:07 am

I am a MoTeC dealer here in romania. I will send it to MoTeC UK. Funny thing is that it done this a couple of times and after worked well, after i managed to update the firmware.... Any idea of what might cause this ?

by **SprinterTRD** on Mon Oct 14, 2019 11:19 am

Sounds like a intermittent hardware issue. A/D = Analogue to Digital in the electronics world.
As David suggested, Time to send it back to MoTeC

by **Vlad** on Mon Oct 14, 2019 8:17 pm

This is my own dash, from my project car. The USB Driver is working ok, just when i want to read/write it shows this...Off it goes to MoTeC.

SDL Can error

SDL Can error

Re: SDL Can error

Re: SDL Can error

Re: SDL Can error

Re: SDL Can error

Re: SDL Can error

Who is online