PDM/Keypad CAN-output to M800

Discussion and support for MoTeC Power Distribution Modules

Re: PDM/Keypad CAN-output to M800

Postby cotje on Thu Apr 15, 2021 6:35 am

Good news David, got both variations working like a charm! First I configured the PDM>M800 as your example and the cycle-values showed up correctly. Thereafter I changed the config in CDL to receive the PDM-keys and combined those with the GPS-speed to be sent to the M800. After some tricking around with multipliers I got the numbers showing up on the M800 for the Boost-Key-Cycle and the ORB-Key-Cycle. The Boost value is now used as a table Y-axis value. For the ORB value I'm still looking to use it as an input-conversion for the two features (13/24). I noticed the digital input functions that can be mapped to the ADL CAN Channels. Did a short test but failed to trigger that input with the ORB-channel. Any hints from your side? TIA!
cotje
 
Posts: 58
Joined: Mon Oct 07, 2013 4:50 am

Previous

Return to PDM15 PDM16 PDM30 and PDM32

Who is online

Users browsing this forum: No registered users and 1 guest