Page 1 of 1

LTC CAN Bus Messages

PostPosted: Thu May 05, 2011 8:04 pm
by Mazi
There is also Message 3, ID-2 available but not documented.
Unknown messages are sent out from LTC on address 1CF8xxxx.

Any info available?

Re: LTC CAN Bus Messages

PostPosted: Tue Jun 21, 2011 4:56 pm
by JamieA
It is a debug message for Motec diagnostic use only.

you wont need to worry about it.

what version are you using, as I thought it wasnt meant to send it.

regards..

Jamie

Re: LTC CAN Bus Messages

PostPosted: Wed Jun 22, 2011 12:11 pm
by Mazi
Jamie

Firmware version is 1.04C

Re: LTC CAN Bus Messages

PostPosted: Fri Dec 04, 2020 10:51 pm
by Powertrain
Hi there,
it is possible to setup the LTC Controller without sending the Motec diagnostic messages?
When yes, how to do this?

Re: LTC CAN Bus Messages

PostPosted: Mon Dec 07, 2020 9:16 am
by adrian
No it isn't possible to turn the messages off, they are used for PC communications.

The address range of the messages is 0x1CF80000 to 0x1CF8FFFF.