MDC diff pump request output via CAN

Discussion and support for MoTeC's Mitsubishi and Subaru Diff Controllers

MDC diff pump request output via CAN

Postby MikeD on Sat Jul 18, 2020 5:59 pm

Dear MoTeC team,
is there a chance to add diff pump request output to the CAN stream of the MDC (same mirrored signal like pin 16 - Pump relay output), maybe added to the existing diagnostic flags CAN frame?

The purpose would be to activate a pump via CAN and keep all the pump logic that you already have inside the MDC (with manual bleed override, safety timeout and so on).

I imagine the MDC's become older yet they are still used for new builds that do all the stuff via CAN nowadays.

Kind regards,
Mike
MikeD
 
Posts: 3
Joined: Fri Nov 29, 2019 4:45 am

Re: MDC diff pump request output via CAN

Postby RR213 on Sun Oct 11, 2020 4:40 pm

+1 for this.

Alternatively if the Pump Relay Output pin could be configurable as optionally low side drive for applications where an MDC is used in other than a plug and play scenario. Same for brake switch input would also be helpful.
RR213
 
Posts: 6
Joined: Tue Jul 09, 2019 5:01 am

Re: MDC diff pump request output via CAN

Postby adrian on Tue Oct 13, 2020 3:52 pm

Unfortunately due to the age of the MDC we are no longer updating the functionality or software.
adrian
MoTeC
 
Posts: 608
Joined: Mon Apr 13, 2015 4:16 pm


Return to MDC and SDC

Who is online

Users browsing this forum: No registered users and 1 guest