SDC3 - skip/bypass/eliminate relay ?

Discussion and support for MoTeC's Mitsubishi and Subaru Diff Controllers

SDC3 - skip/bypass/eliminate relay ?

Postby phatbob on Thu Aug 30, 2012 3:19 am

Hi

I'm installing an SDC3 in a standalone harness, trying to simplify / eliminate a few things

the SDC3 uses pin 7 (switches internally to ground) to drive the relay for the diff itself, which when activated (pin 7 internally grounds) sends +12v down pins 13 and 14.

Is there any negative side effect to eliminating this and just powering pins 13/14 permanently (aside from the fact that the controller cant shut off the power, which should be ok since its controlling the ground anyways) ? or is keeping this a 'must' ?

thanks
phatbob
 
Posts: 14
Joined: Sun Jun 10, 2012 10:48 pm

Return to MDC and SDC

Who is online

Users browsing this forum: No registered users and 3 guests

cron