M400 with motec GPS sensor - Trackmapping

Information about using GPS units with motec devices

M400 with motec GPS sensor - Trackmapping

Postby extonson on Sun Mar 30, 2014 11:33 am

Hi - I have a m400 and I have installed the gps from motec- it is positioned on the roof, outside the car.
I would like to create a track map , but it's not happening. I have checked the channels , and I see data and position when online with the ecu , I have used a handheld gps and have to start line and finish line coordinates. I can find no where in i2 to enter these to create the beacons. I have created a map of a trip around the block , and that worked ok - the start and the finish was in the same spot - but I can't get this to work at the track - does motec have a procedure for doing this , starting to get frustrated!!!!
extonson
 
Posts: 8
Joined: Sat Oct 31, 2009 8:35 am

Re: M400 with motec GPS sensor - Trackmapping

Postby mstech on Sun Mar 30, 2014 10:16 pm

See my reply to your other question.
mstech
 
Posts: 52
Joined: Mon Nov 05, 2012 11:47 am


Return to GPS Information

Who is online

Users browsing this forum: No registered users and 1 guest