depo windband meter gauges

Discussion and support for MoTeC's new entry level ECUs

depo windband meter gauges

Postby EagleEyeMotors on Sun Nov 15, 2020 9:20 am

depo wind band meter gauge use BOSCH 4.9 windeband meter that provide analog output that can connected to standalone ECU

analog output wire harness instruction for depo windband gauge

black - engine ground ( gose to ground do I have to connect it to ECU ground?)

brown - wideband analog output 0-5v ( were I can connect this one ?)

green - narrow band meter 0-1v ( were I can connect this one ?)

motec m84 has

pin 25 - lambda 1 sensor input

pin 26- lambda 1 pump current (this one for what exactly )

how I connect my LSU 4.9 BOSCH sensor were I connect brown and green wires ?
EagleEyeMotors
 
Posts: 17
Joined: Sun Oct 29, 2017 12:38 am

Re: depo windband meter gauges

Postby SDean on Mon Nov 16, 2020 8:19 am

Hi,

If the wideband meter is controlling the Lambda sensor then you only need to use the wideband output from the meter in to the M84, and let the meter control the sensor.

Using the brown (wideband analogue output) into pin B25 and setting up a custom lambda table in the Input Setup will get the signal into the M84. The black ground wire should go to a common ground with the M84. The green narrow band output is not used.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
SDean
Site Admin
 
Posts: 822
Joined: Tue Dec 02, 2014 9:29 am
Location: Melbourne


Return to M84 ECUs

Who is online

Users browsing this forum: No registered users and 2 guests