New to Motec, wiring ?

Discussion and Support for MoTeC's M1 series ECUs

New to Motec, wiring ?

Postby Tking0007 on Fri Feb 14, 2020 5:01 am

Is there anywhere that shows how things are supposed to be wired. I have the M182 with the E888. Add-ons like trans brake, bump box, egts, etc.. Thanks for any help
Tking0007
 
Posts: 1
Joined: Sun Feb 09, 2020 9:47 am

Re: New to Motec, wiring ?

Postby SDean on Fri Feb 14, 2020 8:47 am

Hi,

What sort of information are you after?

M1 Tune creates a pinout list (Help | Firmware Wiring) that shows which pins are used by a function. Thermocouples are wired directly in to the E888 E88 Wiring documentation

As to individual functions such as solenoids controlling transbrakes and the like, I prefer to wire them to switched VBatt+ and then, dependent on the current draw of the device, low side switch them using either Half Bridges for 2A+ loads, or Low Side Injector/Ignition outputs for low current draws.

You would need to get the details of the device that you are controlling from the supplier of the device.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
SDean
Site Admin
 
Posts: 747
Joined: Tue Dec 02, 2014 9:29 am
Location: Melbourne


Return to M1 ECUs

Who is online

Users browsing this forum: No registered users and 3 guests