Bosch "Motorsport" LSU 4.9 - Calibration

Support forum for users of the M1 Tune

Bosch "Motorsport" LSU 4.9 - Calibration

Postby clarkefarm on Mon Nov 15, 2021 10:04 pm

Just wondering if there are any known issues with using the "Motorsport" version of LSU 4.9 (p/n 1928404687).
I used the factory calibration option in LTC Manager for a normal LSU 4.9 and lambda readings are consistent with a stand alone AFR Gauge at low power settings but there is quite a diversion at high power.
M1 Fuel Aim at 5500 RPM, 95 kpa is .75 and with closed loop this is reported via one of the LTCs (the other is temporarily disconnected while its sensor is being used by the Gauge) but the AFR Gauge is showing .71.
Of course the problem may lie in the Gauge.
The sensor cable connectors have not been altered.
Regards.
Rupert Clarke
clarkefarm
 
Posts: 6
Joined: Sat May 22, 2010 12:42 am

Return to M1 Tune

Who is online

Users browsing this forum: No registered users and 5 guests