LTC CAN Bus Messages

Discussion and support for the MoTeC PLM and LTC's

LTC CAN Bus Messages

Postby Mazi on Thu May 05, 2011 8:04 pm

There is also Message 3, ID-2 available but not documented.
Unknown messages are sent out from LTC on address 1CF8xxxx.

Any info available?
User avatar
Mazi
 
Posts: 145
Joined: Thu Jul 24, 2008 7:45 pm

Re: LTC CAN Bus Messages

Postby JamieA on Tue Jun 21, 2011 4:56 pm

It is a debug message for Motec diagnostic use only.

you wont need to worry about it.

what version are you using, as I thought it wasnt meant to send it.

regards..

Jamie
JamieA
 
Posts: 454
Joined: Wed Apr 30, 2008 2:16 pm
Location: Melbourne, Australia

Re: LTC CAN Bus Messages

Postby Mazi on Wed Jun 22, 2011 12:11 pm

Jamie

Firmware version is 1.04C
User avatar
Mazi
 
Posts: 145
Joined: Thu Jul 24, 2008 7:45 pm

Re: LTC CAN Bus Messages

Postby Powertrain on Fri Dec 04, 2020 10:51 pm

Hi there,
it is possible to setup the LTC Controller without sending the Motec diagnostic messages?
When yes, how to do this?
Powertrain
 
Posts: 1
Joined: Tue Dec 01, 2020 8:25 pm

Re: LTC CAN Bus Messages

Postby adrian on Mon Dec 07, 2020 9:16 am

No it isn't possible to turn the messages off, they are used for PC communications.

The address range of the messages is 0x1CF80000 to 0x1CF8FFFF.
adrian
MoTeC
 
Posts: 630
Joined: Mon Apr 13, 2015 4:16 pm


Return to PLM & LTC

Who is online

Users browsing this forum: No registered users and 0 guests